Need 997 Turbo for datalogging

[Airbag79]

Anyone have a 997 turbo (modified or unmodified) that they would be willing to drive around for 5-10 mins so I can pull intake temperature values with the Durametric tool for a design project of mine. The data would be very useful for my R&D, and greatly appreciated.

I baselined my normally aspirated 987, but I need a forced inducted P car now. If you already have both and could just e-mail me the values that works too. Ideally though I would like to sample both my car and the turbo at same time, so the environmental parameters are consistent, and variation is minimal.

TIA.

[tranman329]

I have some of my old data logs with durametric if you need them. I have a 07 997 turbo.

[Airbag79]

I have some of my old data logs with durametric if you need them. I have a 07 997 turbo.

Yeah, that would be awesome. I just need intake temperature, and the outside temperature as well, or a guesstimate works. My e-mail is airbag1098@gmail.com. Appreciate it.

[Airbag79]

Paging Mike S. Is your beast available one of these Saturdays for a quick run so I can pull some numbers back to back? It would be nice to see what a modified 997 is putting out.

[Silentrun]

Paging Mike S. Is your beast available one of these Saturdays for a quick run so I can pull some numbers back to back? It would be nice to see what a modified 997 is putting out.

I will be at MSR all weekend, should get some good readings after a run:)

[Airbag79]

I will be at MSR all weekend, should get some good readings after a run:)

Good deal! Would greatly appreciate some numbers. :thumbsup2:

[Airbag79]

I will be at MSR all weekend, should get some good readings after a run:)

Also, what are you putting down at the rear wheels now?

[Silentrun]

Also, what are you putting down at the rear wheels now?

no dyno numbers since latest tune, yet...last time and with a poor tune was 476 at the wheels.