Look at my 351w v8 rx7 dyno sheet

[CTK]

Dyno Sheet
http://i967.photobucket.com/albums/ae154/ctk423/DynoSheet.jpg

Mods

walbro 255 fuel pump aluminum edelbrock performer rpm heads with 2.02/1.6 valves it has screw in studs and guide
plates with comp pro push rods. edelbrock rpm upper and lower intake with 24 lbs injectors and 77mm maf sensor,
A9L Ecu. 75mm throttle body, trick flow 2001 cam, crane 1.6 roller rockers. keith craft racing adjustable timing
chain and gears, high volume oil pump, SFI Harmonic Balancer and Flywheel. Centerforce Dual friction clutch,
tremec t-5 transmission, Custom balanced driveshaft with driveshaft loop. custom Hydrolic wilwood clutch master
and slave cylinder, spicer u-joints. MSD ignition and coil.

[mbowdo20]

Very nice!

[CTK]

thanks for the props

[Mr. Hollywood]

That's...cute.

[Mr.Big]

is it used as a starter motor for something else?:p

[CTK]

well it works well in a 1979 rx7 that weighs like 2,500 lbs with driver

[Mr. Hollywood]

I make more rwhp and torque than that......in reverse.

[Flat6]

why not do an all aluminum LS3 if you're going to go thru the trouble of fitting a v8 in a rx7. its lighter and makes way more power in stock form.

or did you buy the car in its current configuration? you mentioned in another thread that the claimed 11 second 1/4 this car supposedly ran was per the previous owner...

[BlackSheep]

It would definitely be faster with a chevy in it!

[CTK]

why not do an all aluminum LS3 if you're going to go thru the trouble of fitting a v8 in a rx7. its lighter and makes way more power in stock form.

or did you buy the car in its current configuration? you mentioned in another thread that the claimed 11 second 1/4 this car supposedly ran was per the previous owner...

yeah i bought it like that... but now i know that 11.2 can be achieved by looking at dyno sheets... so yeah i just got to get better at shifting and launching

[pablo e46]

Are you guys busting his balls just to be smart arses or are you really that big of a dck:)

[BlackSheep]

Are you guys busting his balls just to be smart arses or are you really that big of a dck:)

You'll figure it out.... Keep reading..

[White_lightning]

why not do an all aluminum LS3 if you're going to go thru the trouble of fitting a v8 in a rx7. its lighter and makes way more power in stock form.

or did you buy the car in its current configuration? you mentioned in another thread that the claimed 11 second 1/4 this car supposedly ran was per the previous owner...

because you can built a 351w for $700;) and if it blows up.. you can build another one:)

[Mr. Hollywood]

Are you guys busting his balls just to be smart arses or are you really that big of a dck:)

As far as I'm concerned....just being a ****.

[BlackSheep]

because you can built a 351w for $700;) and if it blows up.. you can build another one:)

Actually more $ to build a ford small block.. Should of built a chevy 383 complete for 2,500 and made 420rwhp 450rwtq